Interlogix ATS4500A-IP-MM

Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 155
Camera specific options
2.2.2.n.4.9 Pic options
1>Pic settings
>>>
This menu is specific for systems with wireless PIR camera expanders.
See “Using cameras” on page 98 for more details.
2.2.2.n.4.9.1 Pic settings
1>Burglar set.
>>>
The menu allows you to configure photo recording options separately for the
following camera event types:
• Burglar alarms
• Fire alarms
• Panic alarms
• Medical alarms
• Tamper alarms
• Faults: Device faults and technical alarms
• Custom type 1: User programmable type 1
• Custom type 2: User programmable type 2
See also “Camera event types” on page 98.
2.2.2.n.4.9.1.1 Burglar settings
1>Pic amount
1
Enter the BA settings menu to configure picture settings for burglar alarms.
2.2.2.n.4.9.1.1.1 Pic amount
1 Pic amount
>1<
Set the number of pictures taken after an event of the selected type occurs.
Allowed range is 1 to 30. The delay between pictures is set in “2.2.2.n.4.9.1.1.2
Frame rate” below.
2.2.2.n.4.9.1.1.2 Frame rate
2 Frame rate
>500 ms<
The menu defines a frequency of taking pictures on an event of the selected
type.
The menu is only available if “2.2.2.n.4.9.1.1.1 Pic amount” above value is larger
than 1.