Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 215
5.2.n Select door group
Select a door group to program.
5.2.n.1 Door Gr name
1 Door Gr name
>Door Gr 2 <
Every door group can be programmed with a name to identify it.
Use the Door Gr name screen to enter or change the door group name. The
name can contain up to 16 characters.
5.2.n.2 Door Gr data
Program the user access for the selected door group.
To configure a door group:
1. Add a door to the group if necessary. The default schedule (Always) is
automatically assigned to every added door.
2. Select a door, to which a user with the assigned door group can have an
access.
3. Assign up to two schedules that define, when users with this door group have
an access to this door.
The shortcut menu allows you to assign up to two schedules to the selected
element.
See “Schedule shortcut menu” on page 78 for more information.
4. Repeat for all doors specific for this door group.
5.2.n.3 Delete Door Gr
To remove a door group, select a door group using the cursor, or by entering the
door group number, and go to the Delete door group menu.
The display shows:
2 Delete Door Gr
>Cancel<
Choose Ok and press Enter. This deletes the door group.
Repeat the command to delete other door groups, or press Clear to exit and
return to the higher menu level.
Note: You cannot delete a door group unless your user group authorizes you to
do so.
To Next Page
Loading...
Need help?
General
