Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 271
9.3.n.4.1 IP config
If the IP config is set to Dynamic, the DHCP is enabled. If this value is Static, you
must configure the other options in this menu that are described below.
9.3.n.4.2 IP address
2 IP address
>000.000.000.00<
You must set the panel IP address prior to use the IP communication, if DHCP is
disabled. If DHCP is enabled in “9.3.n.4.1 IP config” menu above, this value
shows the dynamic IP address that is assigned by the DHCP server and cannot
be changed.
9.3.n.4.3 Subnet mask
3 Subnet mask
>255.255.255.00<
You must set the panel IP subnet mask prior to use the OH 2000 communication
protocol, if DHCP is disabled. If DHCP is enabled in “9.3.n.4.1 IP config” menu
above, this value shows the dynamic IP subnet mask that cannot be changed.
9.3.n.4.4 Gateway
4 Gateway
>000.000.000.00<
You must set the gateway IP address prior to use the OH 2000 communication
protocol in a WAN, if DHCP is disabled. If DHCP is enabled in “9.3.n.4.1 IP
config” menu above, this value shows the dynamic gateway address that cannot
be changed.
9.3.n.5 DNS config
The DNS server must be configured if you use domain names for the Ethernet
reporting.
The following options are configurable in this menu.
9.3.n.5.1 DNS config
If the IP configuration in menu “9.3.n.4 IP config” on page 270 is set to Dynamic
(DHCP is enabled), you can set the DNS configuration option to Static to override
the automatic DNS configuration by DHCP server. Set the DNS address in the
To Next Page
Loading...
Need help?
General
