Interlogix ATS4500A-IP-MM Installation And Programming Manual

Appendix A: Advisor Advanced events
314 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Group
Event
#
Event description
Notes
ZNAM
46
Zone masking
At least one zone in the area is
in anti-mask alarm state
ZNTAMPER
47
Zone tamper
At least one zone in the area is
in tamper state
KEYPADTAMPER
48
Keypad tamper
A keypad assigned to the area is
in tamper state
KEYPADFAULT
49
Keypad fault
A keypad assigned to the area is
in fault state
EXPANDERTAMPER
50
Expander tamper
An expander assigned to the
area is in tamper state
EXPANDERFAULT
51
Expander fault
An expander assigned to the
area is in fault state
DURESS
52
Duress
Duress code used in the area
FSDURESS
53
Duress during full
set
Duress code used while area full
set
PSDURESS
54
Duress during part
set
Duress code used while area
part set
USDURESS
55
Duress during
unset
Duress code used while area
unset
FTCDURESS
56
Duress and FTC
Duress code used while FTC
present
CODETAMPER
57
Code tamper
Active when a keypad assigned
to the area is locked for 2
minutes due to 3 wrong PIN
entries
ENTRY
58
Area entry
Area entry time is active
EXIT
59
Area exit
Area exit time is active
EXITFAULT
60
Exit fault
Alarm detected during exit state
before changing to part or full
set state
RTS
61
Ready To Set
Active when all configured RTS
conditions are valid
SETOK
62
Area set OK
Active for 2 s when area set
successfully
SETFAULT
63
Area set failed
Active during 30 s after
unsuccessful area setting
UNSETOK
64
Area unset OK
Active for 2 sec when area has
been unset
ALARMACK
65
Alarms to ACK
Alarms present waiting for
acknowledge
FIRERESET
66
Fire reset
For FIRE zone, event active for
10 s after fire alarm
acknowledge (also inhibits fire
zone for 15 s). Also active for 10
s during fire zone walk test

Interlogix ATS4500A-IP-MM Specifications

General

Brand	Interlogix
Model	ATS4500A-IP-MM
Category	Security System
Language	English