Chapter 3: System functions
90 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
Take a picture and send it to a
central station
1. Camera
2. Central station
Change user access to areas
1. UG identifier
2. Areas selection
3. Area groups selection
1. Areas selection
2. State change: On or Off
1. Areas selection
2. State change: Shunt, Unshunt, Toggle
Show isolated zones, keypads,
and expanders
Enable Request To Exit input
for specific doors
Enable Low security mode for
specific doors
Enable access to doors in a
door group [6]
[1] Depending on system settings, the function may require logging in of a user with the
appropriate privileges. See “2.2.1.n.3.11 Quick set” on page 147 for more details.
[2] Set and part set function start time is the time when the warning timer is started. The warning
time must be taken into account. See “4.2.n.4.1 Warning time” on page 187 for more details.
[3] The function is an entry to the appropriate user menu. See Advisor Advanced Manager
Manual for more details.
[4] The function requires logging in of the supervisor or the installer.
[5] The function requires logging in of the supervisor.
[6] Caution: This function should be only performed in a time frame with specified end time. See
also Chapter 3 “System functions > Counteractions” on page 78.
The described functions can be activated by one of the following:
• Schedule. See “Calendar” on page 77 for more details.
• Function key. See “Function keys” on page 57.
• Fob. See “Wireless device programming” on page 92 for more details.
To Next Page
Loading...
Need help?
General
