Chapter 5: Menu reference
124 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
The zone resistance is displayed.
Values above 65 kΩ are considered as open state.
You can now scroll through the list of inputs by pressing Up or Down.
Note: External expanders (DGP) do not support this functionality.
1.2.1.8 Detector test
Detector test functionality allows remote tests of detectors with a dedicated input
test. The menu allows you to configure automatic detector test parameters, or to
run the test manually.
1.2.1.8.1 Duration
Duration defines how long the test signal is active. The allowed range is 10 to
60 seconds.
1.2.1.8.2 Test time
The time of day the system activates an automatic detector test on.
The allowed range is 00:00 to 23:59, while 00:00 is equal to Off and means that
the automatic test is disabled.
1.2.1.8.3 Test when Set
Defines whether an automatic test is activated or not when the area with the
appropriate detector is set.
1.2.1.8.4 Manual test
Change the value to OK and press Enter to activate the detector test manually.
1.2.1.9 Shunt zones
The menu allows you to shunt zones manually.
To Next Page
Loading...
