Interlogix ATSx500A Series - Page 244

Chapter 5: Menu reference
238 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
8.2.4.2 Tamper
2 Tamper
>No<
If the Tamper option is set to Yes, tamper alarms require an engineer reset.
8.2.4.3 Panic
3 Panic
>No<
If the Panic option is set to Yes, panic alarms require an engineer reset.
8.2.4.4 Confirmed alarm
4 Conf. alarm
>Off<
The Alarm confirm menu defines which AB alarm requires an engineer reset. The
available options are A-ALARM, B-ALARM, or Off (disabled). This is option works
only when AB alarm confirmation is enabled.
8.2.4.5 Battery fail
5 Battery fail
>Off<
If the Battery fail option is set to Yes, battery faults require an engineer reset.
8.2.4.6 Aux fuse
6 Aux fuse
>Off<
If the Aux fuse option is set to Yes, auxiliary fuse faults require an engineer reset.
8.2.4.7 Mains fail
7 Mains fail
>Off<
If the Mains fail option is set to Yes, mains supply faults require an engineer
reset.
8.2.4.8 Siren fault
8 Siren fault
>Off<
If the Siren fault option is set to Yes, siren faults require an engineer reset.
8.2.4.9 Interconn fault
9 Intconn fault
>Off<
If the Interconnection fault option is set to Yes, interconnection faults require an
engineer reset.