Interlogix Simon XT User Manual

Simon XT User Manual 29
Duress code
The duress code, when used in place of another user code, generates a silent
duress alarm which is reported to the central monitoring station.
To change the duress code:
1. Enter the System programming menu.
2. Scroll up/down to Access codes, then press Enter.
3. Scroll up/down to Duress code, then press Enter.
4. The current value of the code now flashes.
5. Enter a new code (use correct length), then press Enter.
6. Press Status repeatedly to exit.
Initially, the duress code is blank. The duress code can be deleted by pressing
Disarm while the code is being changed.
Security
The Security menu contains the Download Enable option. This option determines
whether your dealer can access the system remotely.
To program the Download enable option:
1. Enter the System programming menu.
2. Scroll up/down to Security, then press Enter.
3. Scroll up/down to Download enable, then press Enter.
4. The current value of this option now flashes On/off.
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Phone numbers
Phone #4 is the only system phone number that you can change. Therefore, it is
often used for voice reporting of alarms to your phone, if it was programmed for
this purpose by the installer.
To change Phone #4:
1. Enter the System programming menu.
2. Scroll up/down to Phone #s, then press Enter.
3. Scroll up/down to Phone #4, then press Enter.
4. The first digit of the current value of this option now flashes (this may take up
both lines on the display).

Interlogix Simon XT Specifications

Power

power requirements	6V nominal
standby current	30mA (10mA in PowerSave Mode)
peak current	1.7 A

Operating Environment

operating temperature	32 to 120°F (0 to 49°C)
storage temperature	-30 to 140°F (-34 to 60°C)
max. relative humidity	90% non-condensing

Dimensions

height	4 1/16 in.
width	1 7/8 in.