Intermec CK70

Chapter 6 — Configure the Computer
94 70 Series Mobile Computer User Manual
5 Select the profile you want to configure.
6 For Association, select WPA or WPA2. Encryption automatically
defaults to TKIP or AES, respectively.
7 For 8021x, select TTLS, PEAP, EAP-FAST, or TLS.
8 If you selected TTLS, EAP-FAST, or PEAP:
a For Prompt for Credentials, select Enter credentials now.
b Enter a User Name and User Password.
c For Validate Server Certificate, select Yes.
9 If you selected TLS:
a Load a user and root certificate on your computer. For help, see
“Load a Certificate” on page 102.
b Enter a User Name and Subject Name.
c For Validate Server Certificate, select Yes.
Configure WPA or WPA2 Personal (PSK) Security with Funk
Use the following procedure to configure WPA-PSK or WPA2-PSK
with Funk security.
1 Make sure the communications and radio parameters on your
computer are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Select Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, select WPA or WPA2.
7 For 8021x, select None.
Note: The correct date must be set on your computer when you
enable Validate Server Certificate.