Appendix C — ScanNGo Wi-Fi Configuration Bar Codes
70 Series Mobile Computer User Manual 179
2D Imager Radio Configuration Bar Codes
1D Configuration Bar Codes
You can configure the computer with a 1D imager (EV12).
1 Scan the START HERE bar code from the table and wait for the
program to start.
2 Scan the 1/9 bar code.
3 Scan the rest of the bar codes in any order.
4 Follow any instructions on the device.
When You Want To: Scan This Bar Code
• Set all communication settings to defaults
(Wi-Fi, WWAN if applicable)
• Enable Wi-Fi - set Funk defaults
To Next Page
Loading...
