Intermec EasyCoder PF4i Migration Guide

Printer Migration Guide 1
Printer Migration Guide
Models 3400, 3440, 4420, and 4440
This migration guide helps ensure that your printing operations continue with minimal interruption when
upgrading from an Intermec EasyCoder® 3400, 3440, 4420, or 4440 printer to an Intermec EasyCoder® PF4i,
PM4i, PX4i, PD41, or PD42 printer.
This guide assumes that you are generally familiar with the interior and operations of your printer. If this is not
the case, refer to your new printer user’s guide for fully detailed procedures and illustrations. These documents
are listed below in “Related Documentation.”
One of the most obvious differences between the older and newer printer models is the reliance on the control
panel at the front of the printer. For a brief introduction, see “Control Panel Operation” on page 4.
• The Transferring Supplies section addresses loading and adjusting the new printer to handle partially-used
media and ribbon.
• The Configuration section addresses adjusting the new printer to function as desired.
• The Communication section lists connectivity challenges and finding and setting associated values.
• The Troubleshooting section contains notes on handling possible situations that may arise after loading and
setting up the printer correctly.
Related Documentation
Intermec provides extensive documentation for printers and programming languages available for download
from www.intermec.com. This guide does not cover switching to the Fingerprint programming language.
IPL Reference:
• Intermec Printer Language (IPL) Command Reference Manual (P/N 937-007-xxx)
• Intermec Printer Language (IPL) Developer’s Guide (P/N 934-013-xxx)
Printer Models and Related Documentation
Printer Document Name Part Number
PF4i EasyCoder PF4i Bar Code Label Printer User’s Guide (IPL Version) 934-027-xxx
PM4i EasyCoder PM4i Bar Code Label Printer User's Guide (IPL Version) 934-020-xxx
PX4i EasyCoder PX4i User's Guide (IPL) 1-960625-xx
PD41 EasyCoder PD41 Printer User’s Guide 1-960652-xx
PD42 EasyCoder PD42 Printer User’s Guide 934-009-xxx

Intermec EasyCoder PF4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power consumption (standby)	15 W
Power consumption (printing)	300 W
Media thickness	3/7.5 mm
Maximum label width	104 mm
Maximum label length	0.4 m
Maximum roll diameter	152.4 /213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Product color	Blue, Silver
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	405 mm
Width	244 mm
Height	178 mm
Weight	8000 g