Why does my Intermec EasyCoder C4 Printer keep printing or feeding?
If the Intermec Printer keeps printing or feeding when it shouldn't, it might be due to a label caught on the label gap sensor. Open the top cover, remove the label, and clean the sensor using a cleaning card or isopropyl alcohol. Another possible cause is a firmware problem.
What to do if Intermec EasyCoder C4 is working but not printing?
If the Intermec Printer seems to be working but nothing is printed, and you are using Direct Thermal Printing, verify that the media is intended for direct thermal printing by testing if the paper is blackened by the heat from a hot object (+ 70°C/160°F or more). Check that the heat-sensitive side faces the printhead. If you are using Thermal Transfer Printing, verify that the printer is loaded with thermal transfer ribbon and that the ink-coated sided faces the receiving face material.
How to fix faded printing on Intermec EasyCoder C4?
If the printing on your Intermec Printer is faded, clean the printhead with the cleaning card. If the printing is still faded, increase the density setup.
How to fix Intermec Printer when control lamp doesn't light green?
If the control lamp on your Intermec Printer does not light green when the power is on, make sure the connectors on the power supply are securely plugged into the receptacle on the printer and to an AC outlet.
What to do if Intermec EasyCoder C4 Printer stops and indicator lamp is orange?
If the Intermec Printer stops printing and the indicator lamp lights up orange, it could be due to a problem with the label gap sensor. Try performing an autoadjust in the Test Mode. It could also indicate a media jam or a firmware problem.
Why is the indicator lamp flashing red on my Intermec Printer?
If the indicator lamp flashes red and printing is interrupted on the Intermec Printer, it indicates overtemperature. Wait for the printer to cool down until the indicator lamp switches to green, and the printing (if halted) is automatically resumed.
Why Intermec EasyCoder C4 prints only partial label?
If your Intermec Printer prints only a partial label, it could be because the print carriage is not completely locked or a label is caught on the printhead. Remove the label and clean the printhead.
What to do if Intermec EasyCoder C4 Printer won't feed but control lamp is green?
If the control lamp lights green on your Intermec Printer but it will not feed, make sure the correct type of interface cable is securely plugged into both the printer and the computer.
How to remove label stuck on roller of Intermec EasyCoder C4?
If a label is stuck on the roller of your Intermec Printer, open the peel-off mechanism and use your fingers to peel away the stuck label while manually rotating the roller. Do not use any sharp tools! Clean the roller using a cleaning card or a cotton swab moistened with isopropyl alcohol.
Why Intermec Printer's label taken sensor not holding printing?
If the label taken sensor on the Intermec Printer does not hold printing until the label/tag has been removed, it may be due to the label/tag being bent down because of excessive length and/or too thin or soft media. It could also be that the label/tag is too short (less than 16 mm/.63 inches), or the label taken sensor or cable is defective.
Instructions for connecting the printer to a power source.
Guidance on connecting the printer to a computer via different interfaces.
Steps for installing necessary printer drivers and software.
Step-by-step guide for loading and operating the printer in Tear-Off mode.
Step-by-step guide for loading and operating the printer in Peel-Off mode.
Step-by-step guide for loading and operating the printer in Cut-Off mode.
Procedure for cleaning the printer's printhead using a cleaning card.
Common problems and their solutions for the printer.
List of requirements for upgrading printer firmware via PC or memory cartridge.
Step-by-step instructions for upgrading firmware using a PC or memory cartridge.
To Next Page
General