Intermec EasyCoder C4 User Manual

18 Intermec EasyCoder C4—User’s Guide
Chapter 2— Operation
7 Wind the green edge guide wheel towards the rear of the printer so the
rear edge guides just touch the label roll without actually breaking its
rotation.
8 Thread the labels through the slits in the front edge guides.
9 Peel away the labels from the fi rst 10 cm (4 inches) or so of the liner.
10 Thread the liner around the peel-off bar and insert it inside the peel-
off mechanism so it protrudes from the slot below the mechanism.
11 Hold the labels while pulling at the liner so it becomes tight, then
close the peel-off mechanism.
12 Firmly close the top cover.
13 If loading labels for the fi rst time or if changing from another type or
size of media, perform a Label Gap Sensor Adjustment as described
on page 24. Else, tap the Feed key either 4 times or until the indicator
lamp glows green.
14 If the printer did run out of labels while printing, the printing will
automatically be resumed.

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English