Intermec EasyCoder C4 User Manual

10 Intermec EasyCoder C4—User’s Guide
Chapter 2— Operation
On/Off Switch
The On/Off switch is located at the back of the printer.
Feed Key
The Feed key can be used in two ways:
• Tapping
• Holding
When power is fi rst applied and the printer is loaded with media (and
possibly ribbon), tapping the Feed key will initiate a formfeed, that is,
media will be fed out to the top of next label or tag.
When power is fi rst applied with no labels loaded, holding the Feed key
will cause the media to be continuously fed out until the key is released.
This mode is useful when replenishing the media supply.
After the media has been threaded through the printer, tapping the Feed
key 3 more times (for a total of 4 taps) will cause a formfeed.
Controls and Indicators
The EasyCoder C4 is controlled by the operator by means of an On/Off
switch, a “Feed” key, and a multi-color indicator lamp.
Indicator lamp
Feed key
EasyCoder
C4
Feed
Power

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English