14 Intermec EasyCoder C4—User’s Guide
Chapter 2— Operation
Label Taken Sensor
The built-in Label Taken Sensor (LTS) can be enabled to hold the
printing until the previous label (or similar) has been removed from the
printer's outfeed slot. As long as the sensor detects a label, the printer will
be BUSY and cannot receive data from host.
If using the ESim protocol described in the ESim v4.00, Programmer’s
Reference Manual, note the following:
• The LTS can be enabled/disabled manually using the switch next to
the sensor (see below) or in the ESim protocol by an O command.
• When switching between peel-off, tear-off operation and cut-
off operation, the media feed must be readjusted by means of a j
command.
The Intermec InterDriver provides options for selecting the following
modes of operation without any j or O commands having to be entered
by the operator:
• Tear-off
• Peel-off with LTS enabled
• Peel-off with LTS disabled
If the printer runs out of media while printing, do not
switch off the power during reload, or data will be lost!
OFF
ON
The Label Taken Sensor can be enabled (on) or disabled (off ) using a manual switch
inside the peel-off mechansim.
To Next Page
Loading...
