Intermec EasyCoder C4 User Manual

Intermec EasyCoder C4—User’s Guide 11
Chapter 2—Operation
Green (solid) Media loaded
Ribbon loaded (TTR only)
Green (flashing) Receiving data
(Test Mode only)
Red (solid) Out of media
Out of ribbon (TTR only)
Printer reset
Red (short flashes) Upgrading firmware
Overtemperature
Red (long flashes) Media jam in cutter
Overheated printhead or
stepper motor
Orange
Error condition detected or
Bootloader active
Dark
Power off
Color Meaning
Indicator Lamp
When the power to the printer is switched on, the indicator lamp will
glow green if the printer is loaded with media and—in case of thermal
transfer printing—ribbon.
If the printer is out of media and/or ribbon, the indicator lamp will glow
red.
Any error condition, such as label stop sensor problems, media jams, or
software errors, will be indicated by the lamp changing to orange, except
for media jams in the optional cutter, which are indicated by long red
fl ashes.
If the indicator lamp fails to work as described above, please refer to
Chapter 4 “Troubleshooting”.

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English