Intermec EasyCoder C4—User’s Guide 7
Chapter 1— Installation
Software Installation
If you intend to use the USB interface, you must start by installing the
Intermec USB printer driver, which is included on the CD-ROM that
comes with the printer.
If you run your EasyCoder C4 from a PC under Windows 95/98/Me,
or Windows NT 4.0/W2000/XP, you may want to install the Intermec
InterDriver and the Intermec LabelShop START found on the CD-
ROM that comes with the printer.
If you use any other operating system than Windows, you will need
to use the ESim protocol described in the Intermec ESim v4.00,
Programmer’s Reference Manual. (Intermec ESim also supports Windows.)
Updates and installation instructions are available at the Intermec home
page http://www.intermec.com.
Note: There are different fi rmware for the 203.2 dpi (8 dots/
mm) and the 300 dpi (11.81 dots/mm) versions.
To Next Page
Loading...
