Intermec EasyCoder C4—User’s Guide 25
Chapter 2—Operation
4 The printer will automatically adjust the label gap sensor and media
feed according to the characteristics of the media. The printer may
feed out 3-4 forms before the adjustment is completed. In case of peel-
off operation, remove the labels as they are fed out.
5 After a delay, a Test Label will be printed and the printer will be placed
in the Dump Mode (see Intermec Esim v4.00, Programmer’s Reference
Manual).
6a Tap the Feed key once to switch back to normal operation, or...
6b ...reset the printer to default setup values by pressing and holding the
Feed key for at least three seconds after the test label was printed. The
indicator lamp will switch to red to indicate that the printer was reset
to default setup. Restart the printer by switching off the power and
then switching it on again.
Refer to the Intermec ESim v4.00, Programmer’s Reference Manual for
illustration and explanation of the test label.
To Next Page
Loading...
Need help?
General