Installing the Cutter on the PF8t
1 Disconnect power and place the printer on a flat surface.
2 Open the top cover by pressing the cover open buttons on either side of
the top cover.
3 Press the green locking buttons and open the ribbon rewind mechanism.
4 Push in the cover piece locks. Lift and remove the front cover piece.
5 Attach the mounting bracket to the printer.
The electronics compartment contains high voltage
components. Always disconnect the power cord before
opening the electronics compartment.
Im Elektronikfach gibt es Komponenten, die hohe
Spannungen führen. Immer das Netzkabel abziehen, bevor
das Elektronikfach geöffnet wird.
Warnung
To Next Page
Loading...
