7
Ringer Indicator
Flashes when the telephone rings with an incoming call or with a message
waiting signal (See PABX section).
Ringer Volume Switch
Located on the base of the unit (see Figure 4). Move switch to select ringer
volume, ringer off (OFF), ringer low (LOW) or ringer high (HIGH) for ringing on
incoming call.
Recall Button
For PABX use, to carry out call transfers and access other PABX facilities.
Memory Stores
There are 10 buttons able to retrieve 10 memory locations, each able to store
32 digits.
Volume Control
Allows the volume of the incoming caller to be adjusted, in Handsfree/Headset
operation. Simply move the slider switch to give a satisfactory level.
Mute Button
Pressing and releasing this button mutes the microphone so that the caller
cannot hear your conversation. The red LED will light indicating that the mute
is on. Pressing and releasing the button a second time will cancel the mute
and return to normal conversation.
If the telephone handset is replaced on the cradle with the mute “on”, the
mute will automatically be released when the handset is next lifted.
To Next Page
Loading...
