6
Motor Screw
ASSEMBLY INSTRUCTIONS
1
3
Mounting
Bracket Screw
2
2. Remove the mounting bracket by removing the two
mounting bracket screws from the round holes in the
canopy. Then loosen the other two mounting bracket
screws from the J-slots. Retain the mounting bracket
screws for later. Install the mounting bracket to the
outlet box (not included) using the screws and washers
provided with the outlet box.
Warning: To reduce the risk of re electric shock,
or personal injury, mount to the outlet box marked
“acceptable for fan support” and use the mounting
screws and washers provided with the outlet box.
3. Remove the ten motor screws from the underside of
the motor and save for blade arm installation.
1.Turn OFF the electrical power at the main fuse or circuit
breaker.
DANGER: Failure to disconnect the power supply prior to
installation may result in serious injury or death.
Downrod
Clip
Set Screw
Yoke
Downrod
Pin
Downrod
4
4. Remove the downrod clip and downrod pin from the
downrod. Then, loosen but do not remove the two set
screws at the top of the yoke.
To Next Page
Loading...
