Need help?Do you have a question about the Intertek 42193 and is the answer not in the manual?
Contact the Service Department for assistance at 1-877-706-3267, Mon-Fri, 8 a.m. - 5 p.m. Central.
List of all fan components and hardware included in the box for assembly.
Detailed list of screws, connectors, and extensions provided.
List of necessary tools not included with the fan for proper installation.
Diagram illustrating the physical dimensions of the ceiling fan with key measurements.
Suitable for ceilings 8 ft. or higher, using a standard downrod.
For angled or vaulted ceilings, up to 16 degrees, may require a longer downrod.
Important safety warnings regarding installation, operation, and maintenance of the fan.
Information on device compliance with FCC Rules for radio frequency emissions.
Contact details for HKC-US, including address and phone number.
Instructions to shut off power at the breaker and avoid shock hazards.
Guidelines for blade height, mounting to approved boxes, and electrical code compliance.
Caution against using full-range dimmer switches to control fan speed due to humming noise.
Crucial step to turn off electrical power at the main fuse or circuit breaker before starting assembly.
Instructions for attaching the mounting bracket securely to the ceiling outlet box.
Remove ten motor screws from the motor underside for blade arm installation.
Remove downrod clip and pin, loosen set screws at the top of the yoke.
Feed wires through the yoke cover, canopy, and downrod.
Insert downrod into yoke, reinstall pin/clip, retighten set screws. Trim excess wire.
Lift downrod into bracket, aligning tab and slot to prevent rotation and ensure safety.
Connect fan wires to supply wires (white to white, black/blue to black, green to ground). Note for separate light switch.
Align canopy J-slots with bracket screws, rotate, and secure with screws. Tighten all.
Partially insert three blade screws with washers through blade into blade arm. Tighten middle screw first.
Install blade arms to motor underside using previously removed motor screws. Secure each arm fully.
Align light pan slotted holes with fitter plate screws. Turn clockwise and secure with screws.
Connect 9-pin connectors from light pan to light kit. Secure light kit with light pan screws.
Install bulbs into the light kit sockets. Allow bulbs and kit to cool before replacing.
Remove finial, place light cage over threaded rod, and secure with finial.
Attach pull chain extensions to the pull chains. Installation is complete. Turn on power.
Use reverse switch for summer (downward airflow) or winter (upward airflow). Must be fully left or right.
Control fan speed with pull chain: HIGH (1 pull), MEDIUM (2), LOW (3), OFF (4). Light controlled separately.
Check wall switch, circuit breakers, wire connections, and forward/reverse switch position.
Ensure screws are snug, wire connectors aren't rattling, and avoid variable-speed controls.
Check mounting bracket, blade/arm screws, and consider blade balancing or interchanging blades.
Check connectors, blue wire connection, bulb wattage, and faulty bulbs.
Contact Service Department for warranty claims and support.
Details motor warranty for life, parts for one year. Excludes glass, finishes, damage from misuse.
States sole responsibility is repair/replacement. Disclaims consequential damages and implied warranties.
To Next Page
General
