Intertek 42193 - Assembly Instructions: Light Fixture; Step 12: Fitter Plate & Light Pan; Step 13: Light Kit Connection; Step 14: Bulb Installation

Bulb
9
ASSEMBLY INSTRUCTIONS
12. Remove one of the three tter plate screws
preassembled to the tter plate from the round hole
and loosen the other two but do not remove. Align the
slotted holes in the light pan with the loosened screws in
the tter plate. Turn light pan clockwise and replace the
previously removed tter plate screw. Tighten all screws.
13. Remove the three light pan screws from the top edge
of the light pan. Then, connect the 9-pin connectors from
the light pan to the 9-pin connectors from the light kit.
Then, use the three previously removed light pan screws
to secure the light kit to the light pan.
12
13
14
Fitter Plate Screw
Fitter Plate
Light Pan
Slotted Hole
9-pin Connector
Light Pan
Screw
Light Pan
15
15. Remove the nial from the threaded rod. Lift the light
cage over the threaded rod and secure with the nial.
14. Install bulbs into the sockets on the light kit.
Important: Make sure you allow the bulbs and light kit to
cool before you replace the bulbs.
Light Kit
Light Kit
Threaded
Rod
Light Cage
Finial