Intertek Cleanica 360 EL20003 - Page 11

Cleanica 360 ™ 11
Assembly
1. To attach the Cleaning Pad, place the Cleaning Pad
on a at, level oor surface. Lower the bottom of the
Steam Head onto the Cleaning Pad and press down
rmly. The Cleaning Pad will attach to the bottom of
the Steam Head.
2. To remove, pull the Cleaning Pad off of the
Steam Head.
Attaching/Removing the
Cleaning Pad
1. To attach the Carpet Glider, rst attach the Cleaning
Pad (see the “Attaching/Removing the Cleaning Pad”
section).
2. Place the Carpet Glider on a at, level oor surface.
Lower the bottom of the Steam Head onto the Carpet
Glider and press down rmly until the Carpet Glider
is attached to the Steam Head.
3. To remove, pull the Carpet Glider and then the
Cleaning Pad off of the Steam Head.
Attaching/Removing the
Carpet Glider