12 Cleanica 360
™
Instructions for Use
1. Remove all the packaging material.
2. Remove any stickers or labels from the appliance.
Before First Use
1. There are two ways to ll the appliance with
water:
a) Open the Water Tank by turning the Water
Tank Cap counterclockwise and removing the
Water Tank Cap. Use the Measuring Cup to ll
the Water Tank with up to 1 ½ cups (360 ml) of
water. Reattach the Water Tank Cap and turn it
clockwise to close it.
b) Remove the Water Tank from the Main Body.
Open the Water Tank by turning the Water
Tank Cap counterclockwise and removing the
Water Tank Cap. Hold the Water Tank under
a faucet and ll the Water Tank with water (up
to 1 ½ cups [360 ml]). Reattach the Water Tank
Cap and turn it clockwise to close it. Reattach
the Water Tank to the Main Body. The Water
Tank should click into place.
2. Plug the appliance into a power outlet.
3. Switch the appliance on. The Indicator Lights will
turn red to indicate that the appliance is heating
up (heating takes approximately 25 seconds).
Once the appliance has fully heated, the Indicator
Lights will turn blue.
4. Press the Steam Button to start releasing steam.
You can control the volume of steam released
by the appliance by turning the Steam Control
Knob clockwise (to increase the volume of steam)
or counterclockwise (to decrease the volume of
steam).
NOTE: It will take approximately 3 seconds
for the appliance to release an increased or
decreased volume of steam after adjusting the
Steam Control Knob.
5. A full Water Tank will allow you to steam for
approximately 20 minutes. When the Water Tank
is empty, the Indicator Lights will glow red and
ash, indicating the need to add more water.
Power off the appliance and rell the Water Tank.
NOTE: If the appliance is powered off at any point
during operation, such as to rell the Water Tank,
the appliance will need to heat up again before
resuming operation.
Using the Cleanica 360
1. Press the Handle Tube Button to release the
Handle from the Main Body.
2. Attach the Accessory Adaptor to the Main Body.
3. Align the arrow on your chosen accessory
with the arrow on the Accessory Adaptor
and attach the accessory. Turn the accessory
counterclockwise until it is locked into place.
4. To remove the Accessory Adaptor from the Main
Body, press the release button on the Accessory
Adaptor.
Using as a Hand-Held Steam Cleaner
To Next Page
Loading...