How to troubleshoot inTest Test Equipment TP04300 when it does not start?
If the inTest Test Equipment TP04300 does not start, make sure it's plugged in and the facility line voltage is correct. Check the Emergency Off (EMO) button and ensure all circuit breakers are in the “On” position.
What to do if Power Supplies (PS1, PS2) are faulty in inTest Test Equipment?
If your inTest Test Equipment is not providing proper voltages from power supplies (PS1, PS2), first check PS1 and PS2 for proper voltages. If the voltages are incorrect after pressing SW1, replace PS1 or PS2 as needed. If the voltages are correct, check the OCM.
What to do if OCM Assembly is faulty in inTest Test Equipment?
If the OCM Assembly is faulty in your inTest Test Equipment, first check for loose or faulty wiring. Then, verify voltages on the P1/J1 power connector. If needed, replace the OCM Assembly.
What to do if OCM Motherboard is faulty in inTest Test Equipment?
If the inTest Test Equipment OCM Motherboard is faulty, verify voltages on K8 and SW1: K8, pin3 (5vdc to 0vdc when SW1 pressed) and SW1, pins 3 & 2 (5vdc to 0vdc when SW1 pressed). If voltages are correct on K8 and SW1 and the system still doesn't start, replace the OCM Motherboard.
What to do if SW1 (Power On/Off switch) is faulty in inTest Test Equipment?
If SW1 (Power On/Off switch) is faulty in your inTest Test Equipment, verify that K5 latches when SW1 is pressed and re-check K5 voltages with SW1 pressed. Replace SW1 as needed.
General| Temperature Stability | ±0.5°C |
|---|---|
| Airflow | Adjustable |
| Temperature Accuracy | ±1.0°C |
| Controller | Digital touchscreen |
| Airflow Rate | Up to 20 CFM |
| Power Requirements | 208V, 3-phase, 60Hz |
| Dimensions | 24" W x 36" D x 48" H |
| Weight | 350 lbs |
| Transition Time | Typically <10 seconds from +25°C to -55°C |
To Next Page
