Intex 128474GN - Page 12

295
A
S AVE THESE INSTRUCTIONS
English
Page 11
A295I019EN
SET UP (continued)
5. Pressthebuttontoturnonthecontrolunitpanelbuttonsrst.
Pressthebuttontoinatethespatubwallfor8to10minutes
untilitisrmtothetouchbutnothard(see drawing 6).
IMPORTANT:Donotoverinateorusehighpressureair
compressortoinate.
6. Press the button again to turn it off.
7. Replace the air valve cap back.
NOTE: The cap is designed to be screwed on and off. Never exert
forceasthiscouldcausethecompleteinternalinationsystemofthe
valve to come loose. See “Spa Tub Air Valve Fastening” for valve
maintenance.
Inate the Spa Cover Air Bladder
1. Opentheinationvalveandinserttheinationhose(7) into the
valve;presstoinateuntilitisrmtothetouchbutnothard
(see drawing 7).
2. Disconnecttheinationhose(7)fromtheairblowerinationoutlet
and the valve.
3. Replace the controlbaseination cap (5) back; close and recess
theinationvalve.
NOTE: If there is a need to add some air to the spa tub wall or spa
coverairbladderaftertheyhavebeensetup,refertoabove“Inatethe
SpaTubWall”and“InatetheSpaCoverAirBladder”sections.Thecoverairbladderispreinstalledinside
thespacover.Ifitneedstobereinstalled,placetheuninatedairbladderinsidethespacoverlipbefore
inatingthebladder.
Deation
For Spa Tub Wall:
1. Unscrew the cap to reveal the stem, push the stem in and turn 90
degree right to secure it in the down position (see drawing 8).
2. Oncethedeationiscompleted,pushthesteminandturn90degree
lefttoreturnittotheinationposition.
3. Replace the cap back.
NOTE: Todeatethespatubforstorage,see“STORAGE”section.
For Cover Air Bladder:
1. Pullvalvecapoutandsqueezethevalveatitsbaseuntildeated.
2. Close and recess the valve back.
7
7
6
3
Press
4
5
7
5
7
1 2
8
2. Press the button located on top of the control base and remove the back cover (see drawing 3).
3. Unscrewthecontrolbaseinationcap (5)torevealtheairblowerinationoutlet,insertoneendofthe 
 inationhose(7) into the outlet and turn to the right to lock it (see drawing 4).
4. Unscrewtheairvalvecaptorevealthestemintheuppositionforination.Inserttheotherendofthe 
 inationhose(7) into the valve and turn to the right to lock it in position (see drawing 5).