(198PO) AUTO CLEANER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 07/08/2021
198
PO
S AVE THESE INSTRUCTIONS
Page 9
8. Turn on the filter pump and make sure water is flowing through
the micro-screen (6) and the hose adaptor (7). The auto cleaner
is now moving and vacuuming the pool floor. See Fig. 8.
Note: The cartridge filter pump and sand filter pump will clean
the pool water. It’s essential to clean or replace the filter cartridge
or backwash sand media frequently to keep the water clean.
If the auto cleaner starts to stir the debris, sediments on the
pool floor, you will require to clean or replace the filter
cartridge more frequently as the fine sediments are retained
by the cartridge.
IMPORTANT NOTE
7
7. Hold the auto cleaner upside
down below the water surface
to jet out the water. See Fig. 7.
This will evacuate all the air in
the hose and auto cleaner, so
the cleaner will sink to the
bottom of the pool floor.
SETUP INSTRUCTIONS (continued)
8
76
To Next Page
Loading...
