Intex CS7111 User Manual

SAVE THESE INSTRUCTIONS
Page 2
(189PO) MODEL CS7111 SALTWATER SYSTEM & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
189
PO
S AVE THESE INSTRUCTIONS
English
Page 23
MAINTENANCE (continued)
The Copper Ion Test Strips can be used to test the copper ion concentration in the water.
Directions and Use
1. Diptheentirestripintothewaterfor3seconds,thenremoveit
2. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3. Nowcomparethecopperionstrippadtothecolorchartonthepackaginglabel.
The3-WayTestStripscantestthe“FreeChlorine”,“pH”,and“TotalAlkalinity”levelsatthesame
time. We recommend that you test the water chemistry weekly, and maintain the chlorine
concentrationat0.5-3ppm.
Directions and Use
1. Dip the entire strip into the water and remove immediately.
2. Hold the strip level for 15 seconds. Do not shake excess water from the strip.
3. Nowcomparethestrippadtothecolorchartonthepackaginglabel.Ifnecessary,adjustthe
chemical level in the pool water. It is very important, to use the proper technique when testing
the water's chemical level. Read and follow the written strip instructions carefully.
1. Disconnect the power cord from the electrical outlet.
2. After the pool is completely empty, disconnect the Saltwater System from the hoses by
reversing the installation instructions.
3. Air-dry the unit before you store it. This might be a good time to visually inspect and clean the
electrolytic cell.
4. Store the unit and accessories in a dry place. The temperature should be controlled, between
 32degreesFahrenheit(0degreesCelsius)and97degreesFahrenheit(36degreesCelsius).
5. The original package can be used for storage.
INTEX
®
3-WAY TEST STRIPS (PACKED WITH THE PRODUCT)
LONG TERM STORAGE
INTEX
®
COPPER ION TEST STRIPS (PACKED WITH THE PRODUCT)

Intex CS7111 Specifications

General

Brand	Intex
Model	CS7111
Category	Swimming Pool Filter
Language	English