EasyManuals Logo
Home>Intex>Swimming Pool Heater>HT30220

Intex HT30220 User Manual

Intex HT30220
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
114A
SAVE THESE INSTRUCTIONS
Page 5
(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.3” PANTONE 295U 11/16/2011
English
SSEETT--UUPP IINNSSTTRRUUCCTTIIOONNSS
SET UP INSTRUCTIONS
The appliance is ready to work under the following conditions:
FREE CHLORINE (HCLO + CLO) up to 3 ppm
pH 6.8 - 8.0
CHLORIDES up to 250 ppm
ISOCYANIC ACID up to 100 ppm
CALCIUM HARDNESS up to 500 ppm
BROMIDE (HbrO) up to 8 ppm
IMPORTANT: The electrical pool heater must be installed as the last piece
of pool equipment before the saltwater pool or chlorine generator system in
the water return line to the pool.
1. Assemble the above-ground-pool (AGP) and its filter pump per
installation instructions.
2. Remove the electrical pool heater and it’s accessories from the
packaging.
3. Place the electrical pool heater in line after the filter pump.
4. Connect the hose (1) to the electrical pool heater inlet. (See following
page)
5. If your above-ground-pool is filled up with water, unscrew the strainer
grids from the strainer connectors and insert the black hat-like plugs into
the strainer connectors before electrical pool heater installation. Go to
step 6 directly if your pool is empty.
6. Disconnect the water return (to the pool) hose from the filter pump
connection, and connect it to the upper electric pool heater connection
with a hose clamp.
7. Connect the second hose to the lower electric pool heater connection
and to the lower pump connection. Make sure all the hose clamps (2)
are tight.
8. If applicable, return strainer grids to strainer connectors inside pool after
removing black hat-like plugs that prevented water from flowing out of
the pool.
9. Connect the electric pool heater to the power outlet. Test RCD as
shown on following page.
10. Turn pump on. Check water is flowing through the heater. Then turn
heater on.
IMPORTANT
If the heater is not in an upright position a safety switch will
automatically turn the heater off. Be sure the heater is always in an
upright position while the cord is connected to the power outlet.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex HT30220 and is the answer not in the manual?

Intex HT30220 Specifications

General IconGeneral
BrandIntex
ModelHT30220
CategorySwimming Pool Heater
LanguageEnglish

Related product manuals