114A
SAVE THESE INSTRUCTIONS
Page 9
(114) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.3” PANTONE 295U 11/16/2011
English
ELECTRIC POOL HEATER STATIONARY MOUNTING OPTION
ELECTRIC POOL HEATER STATIONARY MOUNTING OPTION
Some countries, especially in the European community, require the electric
pool heater to be secured to the ground or to a base in a permanent upright
position. Check your local authorities to determine if there is a regulation in
your area regarding above-the-ground swimming pool electric pool heaters.
If yes, then the electric pool heater can be mounted to a platform using the
two holes located in the base. See drawing below.
The electric pool heater can be mounted on a cement base or onto a
wooden platform to prevent accidental falling over. Total assembly must
exceed 18kg. The European norm EN 60335-2-41 requires this product be
secured to the ground or to a base.
1. The mounting holes are 6.4 mm in diameter and spaced 156 mm apart.
2. Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.
156 m
m
To Next Page
Loading...
Need help?
General
