What to do if my Intex KOM0036 works only on battery?
If your Intex UPS is only working on backup power, there could be several reasons: 1. The power cord might be disconnected. Ensure the cord is properly connected. 2. A fuse might have blown. Replace the fuse with a new one. 3. There might be a power outage, or the voltage from the power line is too low or too high. This is normal UPS behavior.
Why is my Intex KOM0036 UPS beeping?
A beeping sound from your Intex UPS indicates one of two things: * It is overloaded, so you should disconnect any excessive load. * The battery is low and needs to be charged.
Describes the UPS as a standby Uninterruptible Power System providing surge protection and battery charging.
Covers inspection, power cord connection, equipment connection, and battery charging recommendations.
Details electrical specifications including VA rating, voltage, frequency, battery type, transfer time, indicators, and alarms.
Lists common UPS problems, their possible causes, and recommended actions for resolution.
Provides instructions for the correct disposal of the product as Waste Electrical & Electronic Equipment.
General| Brand | Intex |
|---|---|
| Model | KOM0036 |
| Type | Line Interactive |
| Output Power | 360W |
| Battery | 7Ah |
| Waveform | Simulated Sinewave |
| Output Power Capacity | 600VA |
| Nominal Input Voltage | 230V |
| Output Voltage | 230V |
| Frequency Range | 50Hz/60Hz |
| Battery Type | Lead-acid |
| Battery Voltage | 12V |
| Typical Recharge Time | 4-6 hours |
| Outlets | 3 |
| Protection | Surge Protection, Overload Protection, Short Circuit Protection |
To Next Page
