299
NLA
S AVE THESE INSTRUCTIONS
(299NL) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 08/07/2018
English
Page 28
If there is a need to replace the fi lter motor (for qualifi ed technician only), follow below steps to
disassemble it:
IMPORTANT:
You must drain out any remaining water inside the piping system of the control base
before replacing any parts.
Tools required:
One adjustable wrench and one Philip screwdriver.
NOTE:
The “special wrench tool” is included with the new fi lter pump motor replacement and not
with the spa set.
FILTER PUMP MOTOR DISASSEMBLY
123
456
To Next Page
Loading...
Need help?
General