Intex PureSpa SSP-H-20-1C - Storage

295
A
S AVE THESE INSTRUCTIONS
(295IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 08/10/2018
English
Page 21
MAINTENANCE (continued)
In regions subject to freezing temperatures, drain, clean, disassemble and properly store the spa set and related
components indoors when the temperature drops below 4°C (39°F).
1.
Drain and clean the spa following the “Spa Tub Drainage” and “Spa Tub Cleaning” sections.
2.
 Reversesetupinstructionstodeateanddisassemblethespatub,spacontrolunitandspacoverair
bladder.
3.
 Todeatethetubandthecoverairbladder:
 a)Openthedeationoutletcap
(27)
with the included bolt
wrench
(6) (see drawing 19)
.
 b)Insertdeationhoseadaptor
(28)
intothedeationoutlet.
 c) Insertinationhose
(7)
overthedeationhoseadaptor
(28)
.
 d)Inserttheotherendoftheinationhoseintothetubairvalve
or cover air bladder valve.
 e)Presstheairbubblebuttontodeate.
 f) Whendeationiscompletedreverseabovestepsand
   ensuresthedeationoutletcap
(27)
is securely fastened.
Caution:
Only use for the purpose described in this manual.
 Keeptheinationhoseawayfromwaterorsmallobjectswhenthe
 deationfunctionisactivatedtoavoiddamagetotheblowermotor.
4.
Make sure all the spa components and accessories are thoroughly
clean and dry before storage. Air-dry the spa tub in the sun for an
hour before folding.
5.
Fold the spa tub loosely and avoid any sharp corners to prevent
damage or leakage to the spa tub liner.
6.
Prepare additional new cartridges for next time use.
7.
Store the spa tub and accessories in a dry, temperature controlled, between 0º – 40ºC (32º – 104ºF),
storage location.
8.
The original packing can be used for storage.
STORAGE
Spa Surround
Barefoot areas and relaxing areas around the spa shall be cleaned on a regular basis. No cleaning water may
owintothespaorspawatercycle.Thedirtandcleaningagentsshallberinsedcarefullytodraininthespa
surround.
Spa Tub and Cover Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
• Clean and dry the area to be repaired thoroughly.
• Removethepatchbackingpaperandpresspatchrmlyoverthepuncture.Smoothoutthesurfaceto
remove any air bubbles under the patch.
19
6
7
28
1
2
3
27