Intex Quick-Fill AP622 - User Manual

166
IO
(166IO) AP622 ELECTRIC PUMP ENGLISH 4.875” X 7.25” 09/18/2017
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
INTEX
®
OWNER'S MANUAL
Quick-Fill™ Electric Air Pump, Model AP622
220 – 240 Volt ~ 50 Hz; 12 Volt DC; Rechargeable Battery
166-*IO-R0-1809
•
Adult use only.
•
Do not drop unit into water or expose unit to rain or water.
• Do not direct air stream at face or body.
• Do not operate for more than 10 minutes at a time. Unplug and
let cool at least 30 minutes.
•
Unplug unit when not in use.
• Do not obstruct vent holes or open source.
• Do not insert objects into the inflation or deflation connector.
• To reduce the risk of electric shock, do not expose to rain.
Store indoors.
•
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• The appliance is only to be used with the power supply unit
provided with the appliance. It must only be supplied at safety
extra low voltage corresponding to the marking on the
appliance.
FOLLOW THESE RULES AND ALL INSTRUCTIONS TO
AVOID PROPERTY DAMAGE, ELECTRIC SHOCK, BURNS
OR OTHER INJURY.
WARNING
SAVE THESE INSTRUCTIONS
Page 1

Intex Quick-Fill AP622 Specifications

General

Model	AP622
Category	Water Pump
Type	Submersible
Voltage	220-240V
Frequency	50Hz

Summary

Names of Parts

General Information and Safety Notes

Charging and Recharging Instructions

Charging with AC Adapter

Connect the AC adapter to the pump and a 220-240V outlet. Set switch to 'O' to charge for 10 hours or overnight.

Charging with 12 V DC Power Source

Connect the DC cord to the pump and a 12V DC outlet. Set switch to 'O' to charge for 1 hour.

Inflation Procedure

Inflation using 12 V DC Power Cord

Connect DC cord, attach nozzle/connector to valve, set switch to 'I' to inflate, then 'O' to stop.

Inflation without Power Cord

Attach connector/nozzle to valve, set switch to 'II' to inflate, then 'O' to stop.

Deflation Procedure

Deflation using 12 V DC Power Cord

Connect DC cord, attach deflation connector/nozzle to valve, set switch to 'I' to deflate, then 'O' to stop.

Deflation without Power Cord

Attach deflation connector/nozzle to valve, set switch to 'II' to deflate, then 'O' to stop.