Intex Quick-Fill AP642 User Manual

166
IO
(166IO) AP642 ELECTRIC PUMP ENGLISH 4.875” X 7.25” 05/23/2019
SAVE THESE INSTRUCTIONS
Page 1
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
INTEX
®
OWNER'S MANUAL
Quick-Fill™ Electric Air Pump, Model AP642
220 – 240 Volt ~ 50 Hz; 12 Volt DC; Rechargeable Battery
166-*IO-R0-2005
•
Adult use only.
•
Do not drop unit into water or expose unit to rain or water.
•
Do not direct air stream at face or body.
•
Do not operate for more than 10 minutes at a time. Unplug and let cool at least
30 minutes.
•
Unplug unit when not in use.
•
Do not obstruct vent holes or open source.
•
Do not insert objects into the inflation or deflation connector.
•
To reduce the risk of electric shock, do not expose to rain. Store indoors.
•
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
•
Children shall not play with the appliance.
•
Cleaning and user maintenance shall not be made by children without supervision.
•
The appliance is only to be used with the power supply unit provided with the
appliance. It must only be supplied at safety extra low voltage corresponding to the
marking on the appliance.
•
Charging operations shall be carried out in accordance with the instructions provided
herewith, see section “CHARGE/RECHARGE INSTRUCTIONS”.
FOLLOW THESE RULES AND ALL INSTRUCTIONS TO AVOID PROPERTY
DAMAGE, ELECTRIC SHOCK, BURNS OR OTHER INJURY
.
WARNING

Intex Quick-Fill AP642 Specifications

General

Brand	Intex
Model	Quick-Fill AP642
Category	Water Pump
Language	English

Summary

Parts Identification

General Usage Instructions

Initial Charging Requirement

Pump requires charging before first use and cannot inflate directly from AC power.

Recommended First Charge

First charge recommended for 10 hours or overnight via AC adapter.

Alternative Initial Charging

Initial charge possible via 12V DC cord for one hour.

Battery and Cable Safety

Information on sealed batteries, disposal, and cable replacement.

Charging and Recharging Procedures

Charging via AC Adapter

Step-by-step guide to charging the pump using a 220-240V AC adapter.

Charging via 12V DC Power Source

Instructions for charging the pump using a vehicle's 12V DC outlet.

Inflation and Deflation

Inflation with 12V DC Power

How to inflate items using the pump connected to a 12V DC source.

Inflation Without Power Cord

Instructions for inflating items using the pump's battery power.

Deflation with 12V DC Power

How to deflate items using the pump connected to a 12V DC source.

Deflation Without Power Cord

Instructions for deflating items using the pump's battery power.