Intex Quick-Fill AP641 - User Manual

166
PO
(166PO) AP641 ELECTRIC PUMP ENGLISH 4.875” X 7.25” 05/06/2021
READ AND SAVE THESE INSTRUCTIONS
Page 1
PARTS DESCRIPTION:
1. PUMP
2. INFLATION CONNECTOR
3. DEFLATION CONNECTOR
4. SWITCH
5. DETACHABLE 12V DC
POWER CORD
6. AC ADAPTER
7. NOZZLES
8. SWITCH OPERATION DETAIL
9. VENT HOLES / SLOTS
OPERATING INSTRUCTIONS
General
• Pump must be charged before use and is not designed for inflation directly from household AC power sources.
• If necessary, the initial charge can be made using the DC power cord plugged into an automobile cigarette lighter or 12V DC
accessory receptacle for one hour. After the first charge, it may be used for inflation (without cords) and recharged using
either the AC adapter or Fast-charged (1 hour only) using the 12 Volt DC power cord. See specific instructions below.
• The “ ” position turns the pump OFF and is also the RECHARGE mode position.
• The batteries are permanently sealed in the pump and cannot be removed or replaced. As the pump weakens from use,
recharge the batteries. Do not wait until they are fully discharged.
• Do not dispose of air pump and its batteries in fire. Check your local regulations for proper disposal instructions.
• Keep away from heat or direct sunlight.
MAINTENANCE INSTRUCTIONS:
No specific air pump maintenance is required. Air pump has no user serviceable parts.
MOVING AND STORAGE INSTRUCTIONS:
Move the product, air pump and accessories to the power source location. Make sure the power cords are free of twist, kink and
knot. Fold the power cords loosely, and return pump, DC power cord, AC adapter and nozzles to package when not in use.
CHARGE/RECHARGE INSTRUCTIONS
Charging the pump using household 110-120 AC voltage:
1. The pump must be charged for 4 hours or overnight with household 110-120 AC voltage.
2. Plug the AC adapter power cord into the air pump power receptacle
(FIG. 1)
.
3. Plug the other end of the AC adapter power cord into a household 110-120 Volt AC electrical outlet
(FIG. 2)
.
4. Slide the switch to “ ” position to charge/recharge the batteries
(FIG. 3)
.
5. When the pump is fully charged, remove the power cord
(FIG. 4)
.
READ AND FOLLOW ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
INTEX
®
OWNER'S MANUAL
Quick-Fill™ Electric Air Pump, Model AP641
12V 8A Rechargeable Battery
NAMES OF PARTS
FIG (1) FIG (3) FIG (4)
220~240V
110~120V
FIG (2)
√
166-*PO-R0-2205
• Adult Use Only.
• Household use only.
• Do not drop unit into water or expose unit to rain or water.
• Do not direct air stream at face or body.
• Do not operate for more than 10 minutes at a time. Unplug and let cool at least 30 minutes.
• Unplug unit when not in use.
• Do not obstruct vent holes or open source.
• Do not insert objects into inflation or deflation connectors. or deflation connectors.
FOLLOW THESE RULES AND ALL INSTRUCTIONS TO AVOID PROPERTY DAMAGE, ELECTRIC SHOCK,
BURNS OR OTHER INJURY.
WARNING
•
To reduce the risk of electric shock, do not expose to rain. Store indoors. CAUTION: This product has more than one connection to
the source of supply. To reduce the risk of electrical shock, disconnect all such connections before servicing.
CAUTION
Inflate and deflate
with batteries.
Inflate and deflate
with DC power.
Inflation OFF and recharge mode ON with AC or DC power.
8
7
9
1
2
3
4
5
6

Summary

Safety Precautions

Warnings

Essential safety warnings to prevent injury, property damage, electric shock, and burns.

Cautions

Important cautions for safe operation, electrical safety, and product care.

Product Identification and General Use

Parts Description

Identifies and labels all components of the Quick-Fill electric air pump.

General Operation

Overview of pump usage, initial charge, and general advice for operation.

Operating and Maintenance Instructions

Operating Instructions

Detailed steps for using the pump for inflation and deflation.

Maintenance and Storage

Guidelines for pump maintenance, moving, and storage when not in use.

Charging Procedures

AC Power Charging

Instructions for charging the pump using a household 110-120V AC adapter.

DC Power Charging

Instructions for charging the pump using a standard automobile 12V DC power source.

Inflation and Deflation

Inflation Methods

How to inflate items using the 12V DC cord or the fully charged pump.

Deflation Methods

How to deflate items using the 12V DC cord or the fully charged pump.

Intex Quick-Fill AP641 Specifications

General

Brand	Intex
Model	Quick-Fill AP641
Category	Water Pump
Language	English