The pulsator
rotates too slowly
Abnormal noise
and vibration
Water leaks from
wash tub
Power out or switch off
Transmission belt burst
Pulsator is blocked by
something
Belt becomes loose
The exible screw of motor
is loose
The clothes in the spin-dry
tub are unbalanced
Something was stuck between
pulsator and wash tub
The hose is not tightened
with the wash tub
Assemble the transmission belt
Remove the blockage
Tighten the belt or replace it
Tighten the belt and the
screw
Place the clothes neatly
Remove it.
Tighten it
Usage instructions for semi-automatic washing machine
Step 1
Select the wash option (Heavy/Normal/Gentle) on the selector switch
Soak/Wash: Put clothes in the wash tub with water and detergent. Start the
Soak/Rinse function.
For the rst 20 Minutes Soak/Rinse will work and after that clothes will be washed
for the next 15 Minutes.
Step 2
Place the clothes in the spin tub.
Select spin timer for the time period required (For regular 5 mins / Turbodry 10mins)
This is required to remove excess soap
Will result in the rst drying process for the clothes.
Step 3
Transfer clothes to the wash tub.
Rinsing: Fill in water only and select wash time for 3-4 minutes.
After this is complete, select the drain mode to drain out water
Step 4
Drying : Transfer clothes to spin tub and select spin time to complete nal drying
process.
Problem
Reason
Solution
The pulsator
does not rotate
Switch on plug
Trouble Shoot Table
5
To Next Page
Loading...