intrepid 9M - Page 11

22. ____________ ________ Check to see that all clamps on exhaust hose are
tight (on Yanmar engines make sure that
exhaust hose enters water lock at location
marked “in”).
23. ____________ ________ Check engine mount nuts for tightness.
24. ____________ ________ Check shift and throttle cable connections.
25. ____________ ________ Check shift and throttle operation.
26. ____________ ________ With coupling disconnected, check prop shaft
alignment using feeler gauges. See manual for
instructions and tolerances.
27. ____________ ________ Check prop shaft set screws, and see that they
are wired in place.
28. ____________ ________ Start engine according to manufacturer’s
recommendations. Failure to start may be due
to air in fuel lines. Refer to manual for bleeding
directions.
29. ____________ ________ Immediately after engine starts, check to see
that water is coming out of transom exhaust
port.
30. ____________ ________ Check gauges and/or warning lights.
31. ____________ ________ Check entire system for water, oil, fuel, or
exhaust leaks. Note: sealers and paints may
burn off as engine heats up, causing a burning
odor.
32. ____________ ________ Recheck stuffing box.
33. ____________ ________ Report any unusual noises or vibrations to
factory immediately. Do not continue to run
engine if any are present.
WHITE-Return to Intrepid Yachts; YELLOW-Owner’s Copy; PINK-Dealer’s Copy
DEALER’S COMMISSIONING CHECKLIST – PAGE 4
- 11