Invacare 7714P - Attaching Trapeze to Floor Base;Bed End; Adjusting the Grab Bar; Height; Position

Floor Base and Fixed Trapeze 2 Part No 1013153
3. RepeatSTEP2fortheoppositeside.
NOTE:Ensurethatthesnap buttonsfullyprotrudethroughthe
adjustmentholeofthefloorlegassembly.Thisensuresthatthe
FloorBaseisproperlyinstalledandsecurelylockedinposition.
4. Attachtrapezetofloorbase/bedend.RefertoAttaching
TrapezetoFloorBase/BedEndonpage 2.
FIGURE 1 Assembling the Floor Base
Attaching Trapeze to Floor Base/Bed End
NOTE:Forthisprocedure,refertoFIGURE 2onpage 3.
1. Perform oneofthefollowing:
• FloorBase
i. Po sitionthelowerbedbracketinthecenterofthe bottomrailwiththetubularhookfacingDOWN.
ii. Tightenwingnutstosecurelowerbedbracketontobottomrail.
•BedEnd
i. Po sitionthelowerbedbracketin
thecenterofthebottombedframewiththetubularhookfacingUP.
ii. Tightenwingnutstosecurelowerbedbracketontobottombedframe.
NOTE:Positionthelowerbedbracketinthecenterofthebottombedframe.Ifinterferencefromthebeddriveshaft,thetrapezebrackets
MUSTbe
positionedasclosetothecenterofthebedaspossible.
2. Placethetrapezeonaflatsurfaceforeasierinstallationoftheupperbedbracket.
3. Loosenwingnutsontheupperbedbracketandslidethebracketapproximately¾ofthewayupontheoffsetbar.
4. Handtightenthewing
nutsjustenoughtoholdtheupperbedbracketinplaceontheoffsetbar.
5. Installtrapezeassemblyintothesocketofthelowerbedbracket.
6. Positionthetubularhookoftheupperbedbracketsoitrestsonthetoprailoffloorbase/bedend.
7. Securelytightenthewingnuts
tosecuretheupperbedbrackettothetoprailofthefloorbase/bedend.
NOTE:Whenusingthefloorbaseinconjunctionwithabed,thelonglegsofthefloorbaseshouldslideunderthebed.
8. Adjusttheheightand/orpositionofthegrabbar.RefertoAdjustingthe
GrabBaronpage 2.
Adjusting the Grab Bar
NOTE:Forthisprocedure,refertoFIGURE 2onpage 3.
Height
1. PositionanyofthelowerchainlinksontotheʺSʺhook.
Position
1. Loosentrapezekeybyturningcounterclockwise.
2. Slidetheclamptodesiredpositionontheoffsetbar.
3. Securethetrapezeclamptotheoffsetbarbyturningthekeyclockwise.
“A” Frame
Snap Buttons
Short
Length
Floor Base
Assembly
Leg
Leg