Invacare Birdie User Manual (English)

Other manuals for Invacare Birdie

Questions and Answers:

M
Michael GomezAug 18, 2025
What to do if Invacare Lifting Systems electric actuator fails to lift?
- M
  Mary WilliamsonAug 18, 2025
  If the electric actuator on your Invacare Lifting System fails to lift, there are several potential causes: * The hand-control or actuator connector might be loose. Ensure these connectors are properly seated and fully connected. * The battery may be low. Charge the batteries. * The RED emergency stop button may be pressed IN. Rotate it CLOCKWISE until it pops out. * The battery may not be connected properly to the control box. Reconnect the battery to the control box.
C
Cory OchoaAug 20, 2025
What to do if Invacare Lifting Systems patient lift feels loose?
- K
  Kenneth PooleAug 20, 2025
  If your Invacare Lifting Systems patient lift feels loose, it may be due to a loose Mast/Base joint or Tie-Rods. For a loose Mast/Base joint, refer to Assembling the Mast to the Base in the Setup section. If Tie-Rods are loose, contact your Dealer or Invacare representative.
J
Jennifer MillerAug 23, 2025
Why Invacare Lifting Systems control unit beeps during lifting and motor stops?
- J
  Joan MartinAug 23, 2025
  The control unit of your Invacare Lifting Systems emits a beeping sound and the motor stops because the maximum load has been exceeded. Reduce the load for the lift to function normally.
G
Gregory ThompsonAug 25, 2025
What to do if Invacare Lifting Systems boom will not lower in uppermost position?
- V
  veronica69Aug 26, 2025
  If the boom on your Invacare Lifting Systems will not lower from the uppermost position, it requires a minimum weight load to lower. Try pulling down slightly on the boom.
J
Joseph EllisAug 27, 2025
Why is my Invacare Lifting Systems actuator making unusual noise?
- S
  Susan HillAug 28, 2025
  If your Invacare Lifting Systems actuator is making unusual noise, it could be worn or damaged, or the spindle might be bent. Contact your Dealer or Invacare representative.
C
Chelsea WrightAug 30, 2025
How to fix noisy casters/brakes on Invacare Lifting Systems?
- S
  stevennelsonAug 30, 2025
  Noisy or stiff casters/brakes on your Invacare Lifting Systems are likely caused by fluff or debris in the bearings. Clean the casters to remove any fluff and debris.
A
annweaverSep 2, 2025
What to do if Invacare Medical Equipment electric actuator fails to lift?
- Z
  zclarkSep 2, 2025
  If the electric actuator fails to lift or the legs fail to open when the button is pressed, here are a few things to check: * Ensure the hand-control or actuator connector is properly connected and fully seated. * Charge the batteries if they are low. * Make sure the RED emergency stop button is not pressed IN; rotate it CLOCKWISE until it pops out. * Verify the battery is correctly connected to the control box.
T
Taylor ColeSep 4, 2025
What to do if Invacare Medical Equipment control unit emits a beeping sound during lifting and the motor stops?
- G
  Gregory RossSep 4, 2025
  If the control unit beeps during lifting and the motor stops, it means the maximum load has been exceeded. Reduce the load, and the lift should function normally.
J
James RossSep 6, 2025
Why Invacare Medical Equipment patient lift feels loose?
- J
  Justin LucasSep 6, 2025
  A patient lift might feel loose due to: * A loose mast/base joint. * Loose tie-rods.
L
Leah WilsonSep 9, 2025
What to do if Invacare Medical Equipment boom will not lower in uppermost position?
- A
  Anita SmithSep 9, 2025
  If the boom will not lower from the uppermost position, it may require a minimum weight load to initiate lowering. Try pulling down slightly on the boom.