41
7.6 Adjusting the seat height
The seat height can be adjusted to the following heights (measured from chassis / floor):
• 46 / 64 cm
• 48 / 66 cm
• 49 / 68 cm
• 51 / 71 cm
WARNING! Danger of disengaging the drive unintentionally!
• Never use the topmost hole in the tube! In this position the seat is too low and has too little
clearance to the cowling as well as to the declutching lever!
Requirements:
• 2x open-ended spanners 17 mm
• Removing the seat
• Remove the battery and motor compartment
cover.
• Remove the seat pillar locking bolt (1) using both
open-ended spanners.
To Next Page
Loading...
