61
Did the old inner tube get wet during the repair?
If you repaired the old inner tube and reused it, and it became wet during repair, it is much easier
to refit it into the wheel if you lightly powder it with talcum powder.
• Refit the wheel rim parts from outside into the tyre.
• Pump up the tyre lightly.
• Reinsert the nuts and bolts which hold the wheel rim together and tighten fully.
• Make sure that the tyre is properly located on the wheel rim.
• Inflate the tyre up to the recommended tyre pressure (3.5 bar or 50 psi).
• Check to make sure that the tyre is still located properly on the wheel rim.
• Screw the valve cap back on.
• Reassemble the wheel.
To Next Page
Loading...
