To Next PageTo Next Page
What to do if Joystick FAULT displays and the Invacare TDX SP does not drive?
If 'Joystick FAULT' appears and the wheelchair doesn't drive, the joystick or input device is sending a value outside of the normal limits. Replace the joystick or input device.
What to do if the Invacare TDX SP battery indicator flashes low immediately after recharge?
If the battery indicator flashes low immediately after recharging, it could indicate battery failure, a malfunctioning charger, or another electrical issue. Check the batteries for a shorted cell and replace them if necessary.
What to do if the Invacare Wheelchair battery indicator flashes low too soon after being recharged?
If the battery indicator flashes low too soon after being recharged, the batteries may not be charging properly or may be weak. Have the charger checked and replace the batteries if necessary.
What to do if Joystick TIMEOUT displays and the Invacare TDX SP Wheelchair does not drive?
If 'Joystick TIMEOUT' appears and the wheelchair doesn't move, the joystick or input device might be disconnected. Turn off the power, reconnect the joystick or input device, and then turn the power back on.
What to do if CHARGER PLUGGED IN displays on Invacare TDX SP Wheelchair?
If 'CHARGER PLUGGED IN' is displayed, it means the battery charger is connected. Unplug the battery charger from the wheelchair.
What to do if CTRL NOT CONNECTED displays on Invacare TDX SP Wheelchair?
If 'CTRL NOT CONNECTED' is displayed, the CMPJ or Display module isn't communicating with the control module. Check the connections between the joystick or display and the controller. Turn the power off and then back on. If the issue persists, the controller may need replacement.
Why is my Invacare TDX SP Wheelchair sluggish in turns or performance?
If your Invacare Wheelchair is exhibiting sluggish turning or performance, examine it for uneven tire wear, a bent fork or frame, or any loose hardware.
How to fix a User Fault on Invacare TDX SP Wheelchair?
To resolve a user fault, release the joystick to neutral and try again.
What to do if LEFT BRAKE FAULT or RIGHT BRAKE FAULT displays and Invacare wheelchair does not drive?
If 'LEFT BRAKE FAULT' or 'RIGHT BRAKE FAULT' appears and the wheelchair doesn't move, the motor lock levers may be disengaged. Engage the motor lock levers.
What does NEUTRAL TESTING display mean on Invacare Wheelchair?
If 'NEUTRAL TESTING' is displayed, the joystick neutral test has failed. Release the joystick and try to get it back to the center-most position.
General| Type | Power Wheelchair |
|---|---|
| Drive Type | Mid-Wheel Drive |
| Weight Capacity | 300 lbs |
| Battery Range | Up to 15 miles |
| Ground Clearance | 2.5 inches |
| Battery | Group 24 |
| Battery Capacity | 75 Ah |
| Range | Up to 15 miles |
| Seat Width | 16-22 inches |
| Seat Depth | 16-22 inches |
| Drive Wheel Size | 14 inches |
| Caster Wheel Size | 6 inches |
| Back Height | 18-24 inches |
| Overall Width | 24 inches |
| Battery Type | Sealed Lead Acid |
| Backrest Height | 18-24 inches |
| Tire Size | 14 inches |
