Need help?Do you have a question about the inventiv 202093 and is the answer not in the manual?
General| Power | 800 W |
|---|---|
| No Load Speed | 0-1100 rpm |
| Max Drilling Diameter (Concrete) | 26 mm |
| Max Drilling Diameter (Wood) | 30 mm |
| Max Drilling Diameter (Steel) | 13 mm |
Keep work area clean and lit. Avoid explosive atmospheres. Keep children and bystanders away.
Use correct plugs, avoid contact with grounded surfaces, do not expose to water, protect cord.
Stay alert, use PPE, prevent unintentional starting, avoid overreaching, dress properly.
Use correct tool, do not force, maintain tools, keep cutting edges sharp and clean.
Have tool serviced by qualified personnel; check for damage and misalignment.
Guide on how to insert and remove drill bits securely into the tool holder.
Instructions for positioning and tightening the auxiliary handle for safe operation.
How to start and stop the tool using the on/off switch.
Steps to set the tool for hammer drilling into masonry.
Steps to set the tool for standard drilling operations.
Steps to set the tool for chiseling work, ensuring correct selector lock.
Guidance on fitting the dust cover over the drill bit before drilling.
Instructions for refilling grease in the gearbox to maintain hammer efficiency.
Explanation of the safety clutch mechanism and handling jammed bits.
Procedure for cleaning, greasing, and securely installing bits or chucks.
Procedure for safely removing bits or chucks from the tool holder.
Tips for effective drilling and chiseling, including pressure and mode changes.
Cleaning, storage, cord replacement, and common issues like starting or overheating.
To Next Page