Need help?Do you have a question about the INVENTOR NUVI-12WF and is the answer not in the manual?
General| Cooling Technology | Inverter |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Cooling Capacity | 12000 BTU |
| Operating Temperature (Cooling) | 18°C to 43°C |
| Operating Temperature (Heating) | -15°C to 24°C |
General safety warnings, including symbols for danger, caution, and prohibited actions.
Rules for installation, including authorized personnel, parts, location, and storage.
Critical electrical safety rules for wiring, grounding, and power supply.
Precautions regarding installation location, combustible materials, and water exposure.
List of accessories provided with the air conditioning system for installation.
Visual summary of the indoor unit installation process with key steps.
Identification of main parts for both indoor and outdoor units with diagrams.
Guidelines for choosing a suitable installation location for the indoor unit.
Procedures for attaching the mounting plate and drilling the wall hole for piping.
Details on mounting plate sizes and correct placement for unit installation.
Instructions for preparing the refrigerant piping before connection.
Steps for connecting the drain hose for proper water drainage.
Steps for connecting the signal cable between indoor and outdoor units.
Procedures for bundling pipes, wrapping cables, and securely mounting the indoor unit.
Guidelines for choosing an appropriate location for the outdoor unit.
Instructions for installing the drain joint and anchoring the outdoor unit.
Steps for connecting the signal and power cables to the outdoor unit.
Instructions for cutting, removing burrs, and flaring refrigerant pipes.
Guidance on connecting the refrigerant pipes to indoor and outdoor units using torque specs.
Pre-evacuation checks and steps for using vacuum pump and manifold gauge.
Information on calculating and adding refrigerant based on pipe length.
Verifying grounding and checking for electrical leakage during test runs.
Methods for checking gas leaks using soap water or a leak detector.
Essential checks to perform before starting the unit's test run.
Step-by-step guide to performing the test run and required operational checks.
Guidelines for proper disposal and environmental warnings.
Instructions for safely unpacking and repacking the indoor and outdoor units.
Essential safety measures for installation and operation, especially for R32/R290 units.
Guidelines for area checks, work procedures, and safety measures when handling flammable refrigerants.
Safety checks for electrical devices and procedures for repairing sealed components.
Procedures for working with intrinsically safe components, leak detection, and refrigerant removal.
Requirements for refrigerant charging and safe decommissioning of the unit.
Procedures for labelling, refrigerant recovery, and transportation, marking, and storage.
To Next Page