Need help?Do you have a question about the INVENTOR RG10N2(D2S) and is the answer not in the manual?
General| Brand | INVENTOR |
|---|---|
| Model | RG10N2(D2S) |
| Category | Remote Control |
| Language | English |
Instructions for inserting and replacing batteries in the remote control.
Guidance on proper disposal of used batteries according to local laws.
Practical advice for optimal use and signal reception of the remote control.
Compliance information and recommendations for using the remote control.
Indicators showing signal transmission status and battery levels.
Indicators for current mode, fan speed, and special features like ECO/GEAR.
Indicators for temperature, timer settings, louvers, and lock status.
Adjusting the desired operating temperature in 1°C (1°F) increments.
How to select AUTO mode and set temperature; fan speed is automatic.
Steps to select COOL mode, set temperature, and adjust fan speed.
Instructions for using the DRY mode for dehumidification.
How to select FAN mode and adjust fan speed without temperature control.
Steps to activate HEAT mode and adjust temperature and fan speed.
Procedure to set the time for automatic unit activation or deactivation.
An example illustrating how to set both ON and OFF timers sequentially.
How to adjust the louvers' position and activate auto swing.
Starts and stops the horizontal louver movement.
Turns the indoor unit's LED display and buzzer on or off.
Activates energy-saving modes for cooling and electrical consumption.
Activates or deactivates the quiet operation mode by pressing the Fan button.
Sets the unit to operate at high fan speed and 8°C in HEAT mode.
Activates or deactivates the button lock feature by pressing Vane and Turbo.
Allows selection and confirmation of various functions like Active Clean and Sleep.
To Next Page
