Mod. TI-14
Accessories
1 Special wrench
1 Open end wrench 38 mm
1 Open end wrench 10 x 13 mm
1 Open end wrench 19 x 24 mm
1 Open end wrench 24 x 27 mm
1 Allen wrench 5 mm
1 Cutter Shaft(Spindle) Ø3/4” with rings
1 Cutter Shaft(Spindle) Ø1 1/4” with rings
1 Allen wrech 14 mm
1 Instruction manual
Lubrication
Your machine requires lubrication as follows:
The upper bearing should be lubricated every
48 hours of use with a high quality grease,
through point A. Below are makes and types
of greases that can be used on this bearing:
• Darina Grease nº 2 - SHELL
The lower bearing does not need
greasing as it is shielded.
Machine Identification and Replacement Parts
Every machine has a manufacturing code (tag) which provides the manufacturer serial number and production
date. This manual gives listing numbers of parts that form your machine. They provide description and order
numbers. When needed, use original parts; always mention the manufacturing code, part number and quantity
desired.
05
To Next Page
Loading...
Need help?
General
