INVT iMars BG15KTR

iMars grid-tied solar inverters Installation
22
No.
Installation tools
Instruction
5
Allen driver
Fasten the screws, remove and install AC wiring box
6
Straight screwdriver
For AC wiring
7
Megger
Measuring insulation performance and impedance
8
Multimeter
Check the circuit and AC and DC voltage
9
Electric iron
Weld communications cable
10
Wire crimper
Crimp DC terminals
11
Hydraulic clamp
Crimp ring terminal
for AC wiring
4.2.2 Installation place
Select installation site according to below requirements:
(1) The height of the installation position should ensure that the line of sight is at the same
level as the LCD for viewing the parameters inverter conveniently.
Figure 4.3 Optimal mounting height
(2) The installation site must be well ventilated and away from raindrops or direct sunlight.
(3) There must be enough pre-reserved space around the installation site for convenient
installation and disassembly of the inverter and air convection, as shown in Fig 4.4.
Fig 4.4 Installation spacing