INVT iMars BG20KTR

iMars grid-tied solar inverters Display panel
52
Control item
LCD display
Instruction
O
n/Off
control
On/Off Ctrl
ON
OFF
Control the “On/Off” through the panel.
P
ress “ ” and “ ” in the control
interface to select the operation.
P
ress
“ENT
”
to ensure the operation and press
“ESC” to return.
R
estart
Restart
Press ENT to execute.
Press ESC to cancel.
Restart the inverter through the panel.
And save the all settings and operation
record.
Press “ENT” to ensure restarting and the
inverter will begin to self
-inspect or press
“ESC” to return.
Record clear
Clear all Record: Sure˛
Press ENT to execute.
Press ESC to cancel.
Press “ENT” to ensure clear all records or
press
“ESC” to return.
“R
ecord clear” is to clear all
setting
parameters
through the panel, restore
to
the factory setting and save all history
operation records.
R
estore to
factory
Restore to Factory
Press ENT to execute.
Press ESC to cancel.
“Restore to factory” is to clear all setting
parameters and history operation records
through the panel,
restore
to the factory
setting.
Press “ENT”
to ensure clear or
press “ESC” to return.
6.4.8 Mode settings
The default mode of series grid-tied solar inverter is “independent”. But if the current of solar
modules are joined into the inverter as figure 6.12 shows, it is necessary to switch the mode into
“parallel”.
The mode 12kW / 15kW /17kW / 20kW / 25kW / 30kW Please refer to section 6.4.4 for detailed
setting.
Figure 6.12 “Parallel” input mode
Note
z
Only where there is more than 100V DC voltage input, LCD display working, and
AC switch off, can query and modify the inverter DC input mode via the LCD
screen and keypad.